Pool Remodeling California
Rough plaster, dated tile, cracked decking, and a noisy pump do not mean it is time for a new pool. Cen-Cal Pools and Spas rebuilds tired pools across Fresno, Clovis, and the Central Valley with swimming pool remodeling that upgrades the surface, the finishes, and the equipment in one coordinated project.

Typical scope
$15K–$60K, 3–6 weeks, one crew, one warranty.

Before
Worn interior finish, dated waterline, and equipment that costs more to run every summer.

After
New finish, stone detail, modern lighting, and efficient equipment on the same shell.
| Element | Before remodel | After remodel |
|---|---|---|
| Surface | Rough, stained, chipping plaster | Smooth quartz or pebble finish |
| Waterline | Cracked 4x4 tile with calcium buildup | Glass or porcelain tile, sealed clean |
| Coping & deck | Cantilever concrete, hairline cracks | Travertine or paver deck with proper slope |
| Equipment | Single-speed pump, old heater | Variable-speed pump, salt system, automation |
| Monthly cost | High power draw, heavy chemical use | Lower energy and chemical spend |
Pick one upgrade or bundle them into a single remodel, usually cheaper than doing them one at a time over several seasons.
Strip the failing surface and re-finish in white plaster, quartz, or pebble so the water reads clean and the shell is sealed again.
New waterline tile and stone or cantilever coping instantly modernize a 1990s pool without touching the shell shape.
Add a raised spa, tanning ledge, bench, bubblers, or a spillover wall to a pool that was built plain.
Replace cracked concrete with pavers or overlays, correct slope, and fix the drainage problems the original builder ignored.
Swap yellow incandescent lights for color-changing LED and add sheer descents tuned for sound, not splash.
Variable-speed pumps, efficient heaters, salt sanitation, and automation that cut monthly operating costs.
Week 0
We inspect the shell, tile, coping, deck, and equipment pad and tell you what actually needs replacing.
Week 1
Drain, chip out failed surface and tile, protect decking, and prep bond coat.
Weeks 2–4
New tile, coping, plumbing corrections, interior finish, and any added features go in.
Weeks 4–6
Fill, brush, balance chemistry, run equipment, and hand the pool back better than new.
Only need the surface redone? Read our pool plastering page or the replastering and resurfacing guide.
Most pool remodeling projects in the Central Valley run $15,000 to $60,000. A resurface-only project sits at the low end, while a full transformation with new tile, coping, decking, and equipment sits at the top. On-site evaluations are free and quoted line by line.
Most remodels take 3 to 6 weeks from start to refill. Resurfacing alone can finish in 1 to 2 weeks, while remodels that include decking, added features, or equipment relocation run longer.
If the gunite shell is structurally sound, remodeling is almost always the better value. Surfaces, tile, coping, decking, plumbing, and equipment can all be replaced around a healthy shell. We only recommend replacement when there is unrepairable structural failure or the shell sits in the wrong place for the yard.
Yes. Our California pool remodeling scope can include new decking, pavers, hardscape, drainage correction, planting, irrigation, and landscape lighting, all sequenced by one project manager so trades do not undo each other's work.
Usually, yes. Replacing a single-speed pump with a variable-speed unit, adding a properly sized filter, and switching to salt sanitation typically reduces energy and chemical spend enough to offset a meaningful part of the remodel over time.
Free on-site evaluation with honest advice on what to replace and what to keep.